P2674 BMW Fault Code

Description:

BMW Mass Air Flow (MAF) Sensor Intermittent The MAF sensor circuit is monitored by the PCM for sudden voltage (or air flow) input change through the comprehensive component monitor (CCM).

If during the last 40 warm-up cycles in key ON engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory diagnostic trouble code (DTC) is stored.

P2674 Code Symptoms :

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. P2674 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing P2674

P2674 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix P2674 code ?

• Failures of clutch motion/travel sensors.
• Exhaust gas leaks
• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
• Exhaust tube

Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.